Instructions for Using the Catalytic Lamp

1. Choose a location for the lamp: a flat, stable surface away from heat sources and out of reach of children and pets.

2. Use a funnel to fill the lamp body two-thirds full with a suitable catalytic lamp fluid. This fluid can be neutral or scented, and you can mix them to achieve a milder fragrance. Clean any excess liquid from the lamp's body and surface afterward.

3. Insert the burner and ensure its wick is in contact with the fluid. Make sure the stone is properly positioned above the metal base. If this is your first time using the burner, cover the stone with the cap to prevent the fragrance from evaporating, and let the wick soak for 20 minutes.

4. Remove the cap and ignite the burner with a lighter, allowing the flame to burn for two minutes. The flame should be about 7 to 10 cm (3 to 4 inches) high initially and will reduce in size as the burner heats up. Do not leave the lamp unattended during this time, and avoid touching the stone.

5. Blow out the flame and, once extinguished, cover the stone with the protective crown. The stone will be hot, so do not touch it: your lamp is now operational.

6. Allow the lamp to purify the air for approximately 20 minutes in an area of around 10 square meters.

7. To stop the lamp, carefully remove the protective crown, as it may be warm, and cover the hot stone with the metal cap. This will stop the burning and prevent the fragrance from evaporating.

8. For storage, leave the cap and protective crown on the lamp's metal base so it is ready for the next use.